M5 440GP/GX implementation

This course covers AMCC 440GP and 440GX processors


Objectives
	The course explains how to design a 440GX board.
	DDR SDRAM operation is described in order to understand the parameterizing of the memory controller.
	Book E PowerPC architecture is studied, especially the MMU.
	The course provides examples of internal peripherals software drivers.
	Gigabit Ethernet controller and TCP/IP Acceleration Hardware are viewed in detail.
	The training focusses on data path between PCI-X bus and internal PLB bus.
	This course has been delivered several times to companies developing embedded equipments (multimedia systems and avionics systems).
	A chapter on Linux porting can be appended on request.
Labs are compiled with Diab Data compiler and run under Lauterbach debugger.
A more detailed course description is available on request at info@ac6-formation.com


Prerequisites
	Experience of a 32 bit processor or DSP is mandatory.
	Knowledge of PCI-X bus is recommended, see our course reference IC3.
	Knowledge of Gigabit Ethernet is recommended, see our course reference N1.

Plan


INTRODUCTION TO 440GP/GX
	Block diagram
	Internal concurrent transfers examples
	Hardware introduction
	440GP/GX mapping
	Programming model
	Comparison between 440GP and 440GX
CORECONNECT PROGRAMMING INTERFACE
	PLB arbiter, OPB arbiter and PLB-to-OPB bridge configuration
	Bus errors recovering from syndrome registers
	PLB performance monitor
440 CORE
	Pipeline operation
	Internal caches
	CCR0 register
	Speculative loads, storage ordering and synchronization : msync & mbar instructions
	MMU
BOOK E COMPLIANT CORE
	Branch instructions
	Addressing modes, load & store instructions
	Integer instructions
	16-bit mac instructions
	Exception management
	Core timers
	PowerPC EABI
	JTAG emulator use
	Real time trace
CLOCKS, RESET AND POWER MANAGEMENT
	Clocks synthesizer
	Low power modes
	Reset
	Boot routine example
	IIC bootstrap controller
INTERRUPT CONTROLLER & GENERAL PURPOSE TIMERS
	Interrupt masking and acknowledgement e
	Critical interrupt handlers using vectorization
THE INTERNAL SRAM
	Write-through cache, understanding the data and instruction path
	Performance monitor
	SRAM utilization - base address definition
	Access errors
THE DDR-SDRAM CONTROLLER
	DDR-SDRAM operation
	Jedec specification basics
	Hardware interface
	Bank activation, read, write and precharge timing diagrams
	ECC error correction
	Initial configuration following Power-on-Reset
	Address decode
	Timing parameters programming
THE EXTERNAL BUS CONTROLLER
	External bus pinout, driver enables
	Dynamic bus sizing
	Address decoding
	Timing parameters initialization
	Device-paced transfers
	External bus master interface
THE PCI-X BRIDGE
	Data flows
	Inbound an outbound transactions handling
	Address mappings
	Synchronization between CPUs : the MSI registers
	I2O messaging unit, passing messages between processor nodes
	Boot modes, initialization / Reset sequence
THE 4 DMA CHANNELS
	The buffered transfer mode
	Related signals
	Channels bus priority
	Data packing / unpacking
	Buffers chaining
THE FAST/GIGABIT ETHERNET CONTROLLER
	Frame format with and without VLAN option
	Ethernet controller organization
	PHY interface
	Hash table restrictions
	Buffer descriptors management
	Transmit sequence
	Receive sequence
TCP/IP ACCELERATION HARDWARE
	Checksum management
	TCP segmentation in the transmit path
	VLAN tagged frames
THE UARTS
	The UART frame : break, idle, start, stop
	Transmission and reception FIFOs use
	Flow control signals management
THE IIC PORTS
	IIC protocol basics
	Transfer timing diagrams
	Transmit and receive sequences

Durée	Prix	Calendrier
5 jours	2100 €