N3	Ethernet 10 Gigabit

This course covers IEEE802.3 Ethernet 10 gigabit and SFP+

OBJECTIVES This course explains the theory of Ethernet 10 Gigabit from IEEE802.3 standard. Implementation examples are provided for MAC and PHY. The hardware interfaces are fully detailed: XGMII, XAUI, XSBI and XFP+. The course describes the purpose of each unit present in the transmit and receive path. Software aspects, such as 10GBASE-T autonegotiation and more generally registers implemented in PHY sublayers are also covered. Enhancement of MACs, necessary to support 10 Gigabit operation, are studied through Intel 82599. The course details the implementation of 10G Ethernet for backplanes, clarifying 10GBASE-KR FEC, training and autonegotiation. A more detailed course description is available on request at info@ac6-formation.com

PREREQUISITES
	Knowledge of gigabit Ethernet, see our course: Ethernet and switching, reference N1

Plan

INTRODUCTION TO ETHERNET 10G Clarifying the various types of Ethernet 10G PHYs Maintaining backwards compatibility with Ethernet 10/100/1000 Mbps Full duplex only operation MAC / PHY INTERFACE MAC frame assembly XGMII transfer protocol, the 4 Bytes lanes XAUI electrical interface, delay constraints MANAGEMENT INTERFACE Extension to this Clause 22 specification MDIO Manageable Device Electrical interface 10GBASE-X PCS and PMA sublayers 8b/10b coding PCS code-groups, utilization of control characters for signalling Control code groups SKIP sequence PMD 10GBASE-LX4 Introduction to transmission on optical fiber Wave Division Multiplexing PMD 10GBASE-CX4 Using a twinaxial cable Test fixture characteristics 10GBASE-W/R PCS 10GBASE-W/R PCS layer Block formats 64b-66b encoder Scrambler Test pattern functionality WAN Interface Sublayer (10GBASE-W) Introduction to SONET / SDH Framing, scrambling, defect/anomaly detection Mapping of data-units from the PCS into the payload capacity of a STS-192c SPE Receiver, delineation of octet boundaries, checking the BIP octets Error propagation PMA type serial XSBI interface Signal detect handling PMD,TYPE 10GBASE-S, 10GBASE-L, 10GBASE-E Link power budgets Tests PMD registers APM QT2035 SFI/XFI-XAUI PHY and S19235 SONET/SDH transceiver ELECTRICAL DISPERSION COMPENSATION Chromatic dispersion Polarization dispersion Modal dispersion Equalization algorithms Linear vs Limiting electrical interface

PMD, TYPE 10GBASE-LRM (Long Reach Multimode) Preferred launch, alternative launch Fiber types Measurement methods 10GBASE-T 16-level PAM signaling Two-dimensional (2D) symbols 2D symbol selection from a constrained constellation of 128 maximally spaced 2D symbols 65-bit block formats Link training, master / slave operation Scrambling Signaling, forward error correction Test pattern generators PMA stages Compensating for signal attenuation 10GBASE-T PHY specific registers Auto-negotiation, page utilization MDI specification, automatic MDI/MDI-X configuration Test modes, test fixtures ENHANCED SMALL FORM FACTOR PLUGGABLE MODULE SFP+ Low speed electrical and power specification High speed electrical specification I2C interface 10G BACKPLANES Introduction to 10G backplane clauses 10GBASE-KX4 10GBASE-KR Autonegotiation for Ethernet backplanes Forward Error Correction (FEC) MAC ENHANCEMENTS TO SUPPORT 10G Transmitter frame ordering, implementation of several queues Arbitration between queues, utilization of VLAN priority or IP DiffServ Transmitter shaper, tuning the inter-frame gap to avoid burst of frames Managing several input buffer rings Selecting the ring through classification of incoming accepted frames Implementation example: Intel 82599 MAC PCIe interface L2 filter, pool select Queuing in a Virtualized Environment Flow Director Filters Buffer allocation Flow Director Hash Function MAC layer offloads Direct cache access Receiver side coalescing Transmit rate scheduler

 

Durée	Prix	Calendrier
3 jours	1650 €